1.Instllation and Adjustment of Linear Guide Please Hangding the products gently to avoid to influence of the precision of the linear guide ,The block is not allowed to detach the rail or push back to the rail when it is over stroke. if the block need to dismantle from the rail because of the difficulty assembly ,you can order the fake rail from us.（fake rail is a Auxiliary tools which has a smaller size than the guide rail, then push the block from the guide rail to fake rail.when the guide rail is assembly,push the bolck from the fake rail back to the guide rail,pay attention of the reference direction when do these steps)
2.Install Caution When install the products distinguish the referenceguide rail and non-reference guide rail clearly(thereference guide rail has the reference mark and the blockhas a reference-side polished surface.
3.Installation Step of Guideway:
4. Installation menthods of reference linear rail(two ways for choose as following) A ,To use a U-type grip holder to clamp the reference surface of rail and reference side surface of installation step, thenuse the fixed bolt to tighten the rail( tapping hole issuggested), it should fix in turn from one end to the other end.
B,When there is not installation step,first fixed one end of the rail, then according to the following picture,lean the gauge on the reference surface of the rail, adjust the linear accurancy from the guage then fix the rail in turn.
5.Linstallation Methods of Non-reference Linear Guide As showed in the picture Fix the Iron absorption meter onto the block, Read the parallelishm and then fixed the non-reference rail in turn.
6.Distinction of the Lenghended Linear Guide Rail
When rail that need to joint to be lengthened, we will write the samecapital on one set rail, and the continuous Arabic numerals toindicate the joint sequence, the joint end mark the same arabicnumber (as showed in picture)
7.Pairing the use of docking rails
1, rail mounting base should have a base and side datum. 2, the docking partin accordance with the docking mark stitching docking connector should be staggered to install. 3.railinstallation side of the base surtace should be installed when the pressure to ensure that the side surtace and ensurethat the surface coincide. (Specific installation diagram shown in Figure 1, Figure 2)
8.When tightening the bolt,should use a constant torque wrench and install as the recommend torque value as the following table:
9.Protection of Rolling Linear Guide
Because of the scope of application of linear guide isexpanded,various conditions, applications are required touse, in order to adapt to different user' s requirements of sealprotection, special designed as following various sealingmode is for select, please distinguishing when make the
order.
If the work environment is very bad, and the space allow, inaddition to make use of to play tricks of seal completely, alsoadapt to consideration increment the dust palliative"skin tiger'
device(is like diagram)
When used in Low speed occasion, it is strictly prohibitedto cleaned the lubrication of the internallinear block by thegasoling before installation to avoid the falure of lubrication
that add prior to shippment.
10.The Lubrication of Rolling Linear Guide The main purpose of linear guide lubrication is toreduce friction and wear in order to prevent overheatingfrom destruction of its internal structure which will effectthe motor function of linear guide. Rolling linear guidehave been filled with high lubricating grease prior toshippment, to ensure good lubrication during operation,but in order to avoid the loss of lubrication caused by thelack of lubrication, recommend a regular supplementwhen the slider stroke is 50km. When the rounning speedof linear guide is for high speed (V 35m/min).recommend to use of N32 lubrication or connect by pipeto forced lubrication (show as in picture). For low speed (V s 35m/min),recommend to use the lithium lubricatinggrease.